The Ford P2104 Code is an error code that appears when the Powertrain Control Module (PCM) detects that the Throttle Actuator Control Motor (TACM) system is in Forced Idle mode. This error code is triggered when the PCM recognizes that the system is operating in Failure Mode Effect Management (FMEM). The causes of this error
When a Hyundai vehicle experiences a P0276 code, it is signaling a problem with the cylinder 6- injector circuit. This code is set when the control circuit is shorted to ground and the powertrain control module (PCM) detects a driver stage check. This code can be caused by a variety of issues, ranging from an
What is Dodge P2127 Code? Dodge P2127 code is a diagnostic trouble code (DTC) that is stored in the vehicle’s computer when a malfunction is detected in the throttle/pedal position sensor/switch “B” circuit. The code is associated with a few different problems, ranging from a faulty throttle/pedal position sensor/switch, a loose connection in the wiring,
Solution: Repair or replace the transmission control module. The Jeep P0657 code is an error code that can indicate an issue with the transmission control module (TCM). This code appears when the 12-volt voltage supply circuits for the transmission solenoids and pressure regulators are not functioning properly. In order to diagnose what is causing the
The RAM P2BAC Code is a code related to engine performance and is associated with the Powertrain Control Module (PCM) which continuously monitors the fault codes of the engine. When certain critical fault codes are identified, the PCM will illuminate the MIL Lamp and the DTC will become inactive. There are various causes that may
When your Jeep fails to start, it is often due to the P1685 code, which stands for Smart Key Immobilizer Module Invalid Key. This code is sent to the Powertrain Control Module (PCM) when an incorrect key is inserted in the ignition. This could be due to attempted theft, a faulty key, or even a
When it comes to diagnosing and repairing a Chrysler P0735 Code, it’s essential to have a good understanding of the causes and solutions. This code indicates a gear ratio error in the fifth gear, and it is triggered when the transmission control system detects a discrepancy between the expected gear ratio and the actual gear
The Audi P0840 Code is a common issue that many Audi drivers face. It is a transmission fluid pressure sensor/switch A circuit, and it can cause a variety of issues if not addressed. The ECM (engine control module) will detect an unexpected voltage condition on the pressure sensor/switch when the engine starts and the vehicle
Signal Improper Voltage This sub type is used for control module Internal Failures that cannot be assigned to a specific sub type. Having a Cadillac C0575 04 Code can be quite a nuisance. It may indicate a problem with the left front actuator circuit-open circuit, and the battery voltage must be between 9-16 volts for
