When your Dodge vehicle displays the B1C14 code, the Driver Active Head Restraint Control Circuit is open. This code is set by the Occupant Restraint Controller (ORC) when it detects an open or shorted circuit in the Driver Active Head Restraint and Ground Circuits. Drivers must investigate the cause and find a solution to get their Dodge vehicle running again. This article will discuss the causes and solutions to the Dodge B1C14 code.
💥See also: Dodge P0118 Code
Causes and Solutions for Dodge B1C14 Code
| Cause | Solution |
|---|---|
| (R676) ACTIVE HEAD RESTRAINT 1ST ROW DRIVER SIGNAL CIRCUIT OPEN | Check the (R676) Active Head Restraint 1st Row Driver Signal Circuit for open or shorted wiring. |
| (R676) ACTIVE HEAD RESTRAINT 1ST ROW DRIVER SIGNAL CIRCUIT SHORTED TO GROUND | Inspect the wiring for any grounds or shorts and repair or replace any faulty wiring. |
| (Z919) ACTIVE HEAD RESTRAINT 1ST ROW DRIVER GROUND CIRCUIT OPEN | Verify the (Z919) Active Head Restraint 1st Row Driver Ground Circuit is properly connected. |
| DRIVER HEAD RESTRAINT | Replace the Driver Head Restraint if it is faulty. |
| OCCUPANT RESTRAINT CONTROLLER (ORC) | Replace the Occupant Restraint Controller (ORC) if it is faulty. |
Open or Shorted Wiring
When a Dodge vehicle displays the B1C14 code, it is usually due to an open or shorted circuit in the (R676) Active Head Restraint 1st Row Driver Signal Circuit. It is important to inspect the wiring to ensure that all connections are secure and that there are no grounds or shorts. If any faults are found, they should be repaired or replaced.
💥See also: Dodge P2638 Code
Driver Head Restraint
The Driver Head Restraint can also cause the B1C14 code to be faulty or damaged. If the Driver Head Restraint is the issue, it should be replaced immediately.
Occupant Restraint Controller (ORC)
The Occupant Restraint Controller (ORC) is the system’s main component. It detects open or short circuits in the Driver’s Active Head Restraint and Ground Circuits. If the ORC is faulty, it should be replaced to get the Dodge vehicle running again.
Conclusion
The Dodge B1C14 code is set by the Occupant Restraint Controller (ORC) when it detects an open or shorted circuit in the Driver Active Head Restraint and Ground Circuits. The cause of the B1C14 code can be open or shorted wiring, a faulty Driver Head Restraint, or a faulty Occupant Restraint Controller (ORC). To get the Dodge vehicle running again, inspecting the wiring, replacing any defective components, and ensuring that all connections are secure. Following these steps, drivers can effectively diagnose and troubleshoot the Dodge B1C14 code.
👀Look at this: Dodge P1488 Code