Having a Hyundai car with the P0422 code can be a frustrating experience as it can cause your car to run erratically and lead to poor engine performance. This code is a catalyst efficiency below normal (bank 1) code and is triggered when the PCM detects that the rear HO2S-12 switch rate is similar to
The Hyundai P1295 code is an error code that is set when a problem is detected in the power management system of Hyundai vehicles. This code represents an issue with the Electronic Throttle Control (ETC) system, which is a crucial part of the vehicle’s engine. Understanding the cause of this code and how to address
If you own a Hyundai, you may have seen a P0326 code. This code is a signal that the Knock Sensor Circuit Malfunction (Bank 1) has been detected by the ECM/PCM. This means that when the engine speed is between 1000-2200 rpm, the ECT sensor signal is more than 104°F, and the engine load is
Hyundai C1702 Code is a variant coding error that can occur during initialization due to faulty HECU or replacement of EMS, T/M ECU. The error is indicated by a difference in pre-inputted and re-inputted variant code as well as the EEPROM not having a valid variant code. To better understand the cause and solution to
People who own a Hyundai and experience a P2637 code can be confused and overwhelmed by the range of causes and solutions available. Knowing the cause of this code can help when it comes to identifying the best solution. In this article, we will discuss the potential causes and solutions for the Hyundai P2637 code.
The Hyundai P0455 code is a diagnostic trouble code that indicates a large evaporative emission system leak. This code is triggered when the powertrain control module (PCM) detects a large change in the fuel tank pressure with the engine running at cruise speed. This can be caused by a number of different components and factors,
When it comes to Hyundai vehicles, the P0106 Code can be a cause of great distress and frustration. This code points to an issue with the Manifold Absolute Pressure/Barometric Pressure Circuit Range/Performance, and often results from a poor connection, open or short in the MAP sensor circuit, faulty MAPS, and/or faulty ECM. To best diagnose
Solution: Check the CAN high and low line. Repair or replace the connector. Replace BCM or IFU. When your Hyundai vehicle’s diagnostic system indicates a B1614 code, it typically signals a disruption in communication between the body control module (BCM) and the instrument fuse unit (IFU). This code is a generic one and is often
If your Hyundai has the B1448 code, you may be dealing with a Passenger Occupant Detecting System (PODS) Circuit Fault. This issue can be caused by a few different factors, including poor connection of connected parts, a faulty OC, and a faulty SRSCM. To help diagnose and fix the issue, it’s important to understand the
When a Hyundai vehicle experiences a P0276 code, it is signaling a problem with the cylinder 6- injector circuit. This code is set when the control circuit is shorted to ground and the powertrain control module (PCM) detects a driver stage check. This code can be caused by a variety of issues, ranging from an
When a Hyundai is experiencing a P0722 code, the issue is with the output shaft speed sensor. This code is triggered when the vehicle is in drive, second, or first gear and the input shaft speed is over 775 RPM, and the PCM does not detect any OSS sensor signal. This can be a difficult